Mitutoyo 516-807-10 Wear Block sets grade 0, Nominal 1mm Carbide Analogue X axis (drive unit) :

X axis (drive unit) : 80mm/s (MAX)

2-6mm 2 point/ 6-300mm 3 point measurement

Solution not included

An annual calibration of the test block is strongly recommended

Spindle feed error: 0

Mitutoyo 516-807-10 Wear Block sets grade 0, Nominal 1mm Carbide Analogue X axis (drive unit) :A pair of thin, wear resistant Mitutoyo gauge blocks designed to form the end (or ends) of a stack of blocks to absorb normal wear and tear. These are especially economic when the application involves abrasive contact with the end (or ends) of a stack, so that instead of wearing a large proportion of the blocks in a whole set, the wear is largely confined to a pair of relatively inexpensive, and therefore easily replaceable, gauge blocks.